Home › Drivetrain · AB60F AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION SYSTEM

DTC    P0818    Driveline Disconnect Switch Input Circuit

for Preparation Click here


DESCRIPTION

The ECM detects the signal indicating that the transfer is in neutral.
This DTC indicates that the signal indicating that the transfer is in neutral remains on.

DTC Code
DTC Detection Condition
Trouble Area
P0818
The signal indicating that the transfer is in neutral remains ON while the vehicle is being driven under the following conditions for 30 seconds (2-trip detection logic):
  1. Vehicle speed is 25 km/h (16 mph) or more.
  2. Transfer position switch is in 4H.
  1. Short in transfer neutral position switch circuit
  2. Transfer shift actuator assembly (transfer system)
  3. ECM

MONITOR DESCRIPTION

The ECM detects whether or not the transfer is in neutral by monitoring the signal from the transfer shift actuator assembly.
If the ECM detects that the transfer is in neutral under the following conditions, the ECM will conclude that there is a malfunction of the transfer shift actuator assembly, illuminate the MIL and store the DTC:
  1. The transfer shift actuator assembly indicates that the transfer is in neutral.
  2. The transfer position switch is in the "4H" position.
  3. The vehicle is being driven at 25 km/h (16 mph) or more.
  4. The transfer neutral signal has been ON for more than 30 seconds.

WIRING DIAGRAM


C160106E19


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TRANSFER SHIFT ACTUATOR - BODY GROUND)


    C209927E05
  1. Disconnect the D46 transfer shift actuator connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D46-3 (N) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Transfer Shift Actuator)



NG
Go to step 2
OK

GO TO TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM (Click here)  

2.CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - BODY GROUND)


    C209926E15
  1. Disconnect the A28 four wheel drive control ECU connector.

  1. Disconnect the D46 transfer shift actuator connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A28-16 (NP) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Four Wheel Drive Control ECU)



NG
Go to step 3
OK

GO TO TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM (Click here)  

3.CHECK HARNESS AND CONNECTOR (TRANSFER SHIFT ACTUATOR, FOUR WHEEL DRIVE CONTROL ECU - ECM)


    C197708E37
  1. Disconnect the A27 ECM connector.

  1. Disconnect the D46 transfer shift actuator connector.

  1. Disconnect the A28 four wheel drive control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A27-5 (TFN) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to ECM)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)