Home › Brake › BRAKE (FRONT) › FRONT BRAKE

FRONT BRAKE > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL


2. REMOVE FRONT DISC BRAKE PAD KIT


    C154476
  1. Remove the pin hold clip.

    NOTICE:
    The pin hold clip can be used again if it has sufficient rebound; no deformation or wear; and has had all rust, dirt and foreign matter cleaned off.

  1. Remove the hole pins.



    C155461
  1. Remove the front disc brake anti-rattle spring.

    NOTICE:
    The anti-rattle spring can be used again if it has sufficient rebound; no deformation, cracks or wear; and has had all rust, dirt and foreign matter cleaned off.



    C155460
  1. Remove the 2 pads from the disc brake caliper.

  1. Remove the No. 1 and No. 2 anti-squeal shims from each pad.



3. DISCONNECT NO. 7 FRONT BRAKE TUBE


    C154477E03
  1. Using a union nut wrench, disconnect the front brake tube from the disc brake caliper.



4. DRAIN BRAKE FLUID

NOTICE:
Wash brake fluid off immediately if it is spilled on any painted surface.



5. REMOVE FRONT DISC BRAKE CALIPER ASSEMBLY LH


    C154478
  1. Remove the 2 bolts and disc brake caliper from the knuckle.



6. REMOVE FRONT DISC


    C155464E01
  1. Put matchmarks on the front disc and axle hub if planning to reuse the disc.

  1. Remove the front disc.