FRONT BRAKE > REASSEMBLY |
| 1. TEMPORARILY INSTALL FRONT DISC BRAKE BLEEDER PLUG |
Temporarily install the bleeder plug to the disc brake caliper.
| 2. INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP |
| 3. INSTALL PISTON SEAL |
![]() |
Apply a light layer of lithium soap base glycol grease to the entire inner and outer circumference of 4 new piston seals.
Install the 4 piston seals to the disc brake caliper.
| 4. INSTALL FRONT DISC BRAKE PISTON |
![]() |
Apply a light layer of lithium soap base glycol grease to the entire inner circumference of 4 new cylinder boots.
Apply a light layer of lithium soap base glycol grease to the entire outer circumference of the 4 front disc brake pistons where they contact the cylinder boots and front disc brake caliper.
Install the 4 cylinder boots to the 4 front disc brake pistons.
Install the 4 front disc brake pistons to the front disc brake caliper.
| 5. INSTALL CYLINDER BOOT |
![]() |
Install one side of each of the 4 cylinder boots to the front disc brake caliper.
Install the 4 set rings.