Home › Vehicle Exterior › DOOR / HATCH › HOOD

HOOD > ADJUSTMENT

for Preparation Click here


B057104E06

HINT:
  1. Centering bolts are used to mount the hood hinge and hood lock. The hood and hood lock cannot be adjusted with the centering bolts in. Substitute standard bolts (with washers) for the centering bolts when making adjustments.
  2. For bolts without torque specifications, check the standard bolt chart (Click here).



1. INSPECT HOOD


  1. Check that the clearance measurements are within the standard ranges.


    B190504E01


    Standard:

    Area
    Measurement
    Area
    Measurement
    A
    4.0 to 7.0 mm
    (0.157 to 0.276 in.)
    B
    -1.5 to 1.5 mm
    (-0.059 to 0.059 in.)



2. ADJUST HOOD


    B192131
  1. Loosen the 4 hood side hinge bolts.

  1. Move the hood to adjust the clearance to within the standard range.

  1. Tighten the 4 hood side hinge bolts after the adjustment.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }



    B192132
  1. Adjust the height of the hood front end by turning the cushion rubber.

    HINT:
    The cushion rubber can be raised and lowered by turning it.



  1. Adjust the hood lock.



      B220937
    1. Remove the hood lock nut cap.



    2. B220936
    3. Loosen the 2 bolts and nut.



    4. B166030
    5. Adjust the hood lock position so that the striker can enter it smoothly.



    6. B220936
    7. Tighten the 2 bolts and nut after the adjustment.

      Torque:
      8.0 N*m{ 82 kgf*cm , 71 in.*lbf }