VALVE BODY ASSEMBLY > INSTALLATION |
| 1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY |
![]() |
Install the spring and check ball body.
![]() |
Insert the pin of the manual valve into the hole of the manual valve lever.
![]() |
Install the 19 bolts.
Install the detent spring and detent spring cover with the bolt.
| 2. CONNECT TRANSMISSION WIRE |
![]() |
Connect the 9 connectors to the solenoid valves.
Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.
| 3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY |
Coat a new O-ring with ATF and install it to the oil strainer.
![]() |
Install the oil strainer with the 4 bolts.
| 4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY |
![]() |
Install the 4 transmission oil cleaner magnets to the oil pan.
![]() |
Install a new gasket and the oil pan with the 12 bolts.
![]() |
| 5. ADD AUTOMATIC TRANSMISSION FLUID |
| Repair | Fill amount |
| Transmission pan and drain plug removal | 2.1 liters (2.2 US qts, 1.9 Imp. qts) |
| Transmission valve body removal | 4.7 liters (5.0 US qts, 4.1 Imp. qts) |
| Torque converter removal | 6.1 liters (6.4 US qts, 5.4 Imp. qts) |
| 6. ADJUST AUTOMATIC TRANSMISSION FLUID |
Adjust automatic transmission fluid (Click here).
| 7. INSPECT FOR AUTOMATIC TRANSMISSION FLUID LEAK |