OIL PUMP > DISASSEMBLY |
| 1. REMOVE FRONT OIL PUMP BODY O-RING |
![]() |
Remove the O-ring from the oil pump.
| 2. FIX OIL PUMP ASSEMBLY |
![]() |
Place the oil pump body on the torque converter clutch.
| 3. REMOVE CLUTCH DRUM OIL SEAL RING |
![]() |
Remove the 3 oil seal rings.
| 4. REMOVE STATOR SHAFT ASSEMBLY |
![]() |
Remove the 17 bolts, and then remove the stator shaft from the oil pump body.
| 5. REMOVE FRONT OIL PUMP BODY O-RING |
![]() |
Remove the O-ring from the oil pump body.
Remove the oil pump body from the torque converter clutch.
| 6. INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY |
![]() |
Using a dial indicator, measure the inside diameter of the oil pump body bush.
| 7. INSPECT STATOR SHAFT ASSEMBLY |
![]() |
Using a dial indicator, measure the inside diameter of the stator shaft bush.
| 8. INSPECT CLEARANCE OF OIL PUMP ASSEMBLY |
![]() |
Push the driven gear to one side of the body.
Using a feeler gauge, measure the body clearance.
![]() |
Using a feeler gauge, measure the tip clearance between the driven gear teeth and drive gear teeth.
![]() |
Using a steel straightedge and feeler gauge, measure the side clearance of both gears.
| Mark | Thickness |
| 0 | 11.636 to 11.642 mm (0.4581 to 0.4583 in.) |
| 1 | 11.643 to 11.649 mm (0.4584 to 0.4586 in.) |
| 2 | 11.650 to 11.656 mm (0.4587 to 0.4589 in.) |
| 3 | 11.657 to 11.663 mm (0.4589 to 0.4592 in.) |
| 4 | 11.664 to 11.670 mm (0.4592 to 0.4594 in.) |
| 5 | 11.671 to 11.677 mm (0.4595 to 0.4597 in.) |
| 6 | 11.678 to 11.684 mm (0.4598 to 0.4600 in.) |
| 9. REMOVE FRONT OIL PUMP DRIVE GEAR |
![]() |
| 10. REMOVE FRONT OIL PUMP DRIVEN GEAR |
![]() |
| 11. REMOVE FRONT OIL PUMP OIL SEAL |
![]() |
Using a screwdriver, pry out the oil seal.