Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (w/ Navigation System)

REAR VIEW MONITOR SYSTEM (w/ Navigation System) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Use these procedures to troubleshoot the rear view monitor system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.CHECK DTC OF NAVIGATION SYSTEM
      1. Refer to DTC Check/Clear procedures of the navigation system (Click here).
        Result 
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B



      B.
      GO TO NAVIGATION SYSTEM
      A


      4.PROBLEM SYMPTOM CONFIRMATION
        Result 
        Result
        Proceed to
        Symptom does not occur
        A
        Symptom occurs
        B


      B.
      Go to step 6
      A


      5.SYMPTOM SIMULATION

        NEXT


        6.CHECK IF SAME SYMPTOM APPEARS IN NAVIGATION SYSTEM
        1. Refer to Navigation System (Click here).
          Result 
          Result
          Proceed to
          Symptom does not appear
          A
          Symptom appears
          B



        B.
        FOLLOW THE NAVIGATION SYMPTOM CHART TO PERFORM TROUBLESHOOTING
        A


        7.PROBLEM SYMPTOMS TABLE
        1. Refer to Problem Symptoms Table (Click here).
          Result 
          Result
          Proceed to
          Fault is not listed in Problem Symptoms Table
          A
          Fault is listed in Problem Symptoms Table
          B



        B.
        Go to step 9
        A


        8.BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW
        1. Terminals of ECU (Click here).


        NEXT


        9.ADJUST, REPAIR OR REPLACE

          NEXT


          10.CONFIRMATION TEST

            NEXT

            END