AUDIO AND VISUAL SYSTEM (for Radio Receiver Type) > DTC CHECK / CLEAR |
| STARTING DIAGNOSTIC MODE |
![]() |
Turn the ignition switch to ACC.
Turn off the audio system.
While pressing the preset switches "1" and "6" at the same time, press the "DISC AUX" switch 3 times.
| ALL ELEMENT ILLUMINATION MODE AND SWITCH CHECK MODE |
![]() |
Check that all elements are on.
When pressing each panel switch, check that a beep is emitted.
| STEREO JACK ADAPTER CONNECTION CHECK MODE |
![]() |
Press the "SEEK TRACK UP" switch.
Check if the stereo jack adapter is recognized.
| SERVICE CHECK MODE |
Press the "SEEK TRACK UP" switch.
| FINISHING DIAGNOSTIC MODE |
Press the "DISC AUX" switch for 2 seconds or more, or turn the ignition switch off.
| CHECK DTC |
Service check result display
| Display | Original word | Meaning | Action to be Taken |
| good | Good (normal) | No DTCs are detected in both "System Check Mode" and "Diagnostic Memory Mode". | - |
| nCon | No connection | The system recognized the component when it was registered, but the component gives no response to the "Diagnostic Mode ON Request". | Check the power source circuit and the communication circuit of the component indicated by the component code (physical address). |
| ECHn | Exchange | One or more DTCs for "Exchange" are detected in either "System Check Mode" or "Diagnostic Memory Mode". | Go to the detailed information mode to check the trouble area on the DTC list. |
| CHEC | Check | When no DTCs are detected for "Exchange", one or more DTCs for "Check" are detected in either "System Check Mode" or "Diagnostic Memory Mode". | Go to the detailed information mode to check the trouble area on the DTC list. |
| OLd | Old version | Old DTC application is identified and DTC is detected in either "System Check Mode" or "Diagnostic Memory Mode". | - |
| nrES | No response | The device gives no response to any one of "System Check Mode ON Request", "System Check Result Request", and "Diagnostic Memory Request". | Check the power source circuit and the communication circuit of the component indicated by the component code (physical address). |
Device name and physical address
| Physical Address No. | Name |
| 190 | Radio receiver assembly |
Service check mode
Press the "SEEK TRACK" switch to see the check result of each component.
The component code (physical address) is displayed first, and then the check result follows.

Detailed Information Mode
Press the preset switch "2" to go to the "Detailed Information Mode".
Press the "SEEK TRACK" switch to display the physical address and DTC of the component.
Press the preset switch "3" to go to the "Service Check Mode".
It is necessary to distinguish between the displays of the responses to "System Check Result Request" and "Diagnostic Memory Request". In order to distinguish between the information detected in "System Check Mode" and "Diagnostic Memory Mode" in "ECHn", "CHEC", and "OLd" in "Detailed Information Mode", refer to the following:

| DTC CLEAR/RECHECK |
![]() |
Clearing All DTC Memory (when clearing all the memory of the DTCs previously detected)
When the preset switch "5" is pressed for 2 seconds or more during "Service Check Mode", the DTCs for all components are cleared. ("CLr" is displayed at this time.)
Clearing Individual DTC Memory (when clearing the memory of the DTC previously detected individually)
When the preset switch "5" is pressed for 2 seconds or more during "Detailed Information Mode", the DTCs for the target component are cleared.
Press the preset switch "1" to perform the service check again, and check that no DTCs are displayed for all the component codes (physical address).