AUDIO AND VISUAL SYSTEM > Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter |

| 1.CHECK OPERATION OF SPEEDOMETER |
Drive the vehicle and check if the function of the speedometer on the combination meter assembly is normal.
|
| ||||
| OK | |
| 2.CHECK STEREO COMPONENT AMPLIFIER ASSEMBLY |
![]() |
Disconnect the I17 stereo component amplifier assembly connector.
Jack up the drive wheels.
Move the shift lever to N.
Turn the ignition switch to ON.
Using an oscilloscope, check the signal waveform of the meter.
| Item | Content |
| Tester Connection | I17-11 (SPD) - Body ground |
| Tool Setting | 5 V/DIV., 20 msec./DIV. |
| Condition | Drive vehicle at 20 km/h (12 mph) |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - STEREO COMPONENT AMPLIFIER) |
![]() |
Disconnect the I17 stereo component amplifier assembly connector.
Disconnect the H37 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I17-11 (SPD) - H37-35 (+S) | Always | Below 1 Ω |
| I17-11 (SPD) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||