REAR SEAT ENTERTAINMENT SYSTEM > Sound Signal Circuit between Navigation Receiver Assembly and Television Display Assembly |

| 1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - TELEVISION DISPLAY ASSEMBLY) |
Disconnect the I46 navigation receiver assembly connector.
Disconnect the U13 television display assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I46-4 (CDL+) - U13-7 (L1+) | Always | Below 1 Ω |
| I46-5 (CDL-) - U13-8 (L1-) | Always | Below 1 Ω |
| I46-2 (CDR+) - U13-9 (R1+) | Always | Below 1 Ω |
| I46-3 (CDR-) - U13-10 (R1-) | Always | Below 1 Ω |
| I46-4 (CDL+) - Body ground | Always | 10 kΩ or higher |
| I46-5 (CDL-) - Body ground | Always | 10 kΩ or higher |
| I46-2 (CDR+) - Body ground | Always | 10 kΩ or higher |
| I46-3 (CDR-) - Body ground | Always | 10 kΩ or higher |
| U13-11 (SLD1) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||