AUDIO AND VISUAL SYSTEM > Mute Signal Circuit between Radio Receiver and Stereo Component Amplifier |

| 1.CHECK STEREO COMPONENT AMPLIFIER ASSEMBLY |
![]() |
Disconnect the I17 stereo component amplifier assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| I17-1 (MUTE) - Body ground | Ignition switch ACC, Audio system is playing → Changing modes | 3.5 V or higher → Below 1 V |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER) |
![]() |
Disconnect the I4 radio receiver assembly connector.
Disconnect the I17 stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I4-7 (MUTE) - I17-1 (MUTE) | Always | Below 1 Ω |
| I4-7 (MUTE) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||