REAR SEAT ENTERTAINMENT SYSTEM > Mute Signal Circuit between Navigation Receiver Assembly and Television Display Assembly |

| 1.CHECK MUTE SIGNAL CIRCUIT |
![]() |
Remove the television display assembly connector still connected (Click here).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| U13-6 (MUT1) - Body ground | Television display playing | Above 3.5 V |
| Television display changing modes | Below 1 V |
| *a | Component with harness connected (Television Display Assembly) |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - TELEVISION DISPLAY ASSEMBLY) |
Disconnect the I35 navigation receiver assembly connector.
Disconnect theU13 television display assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I35-6 (MUTE) -U13-1 (MUT1) | Always | Below 1 Ω |
| I35-6 (MUTE) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.REPLACE TELEVISION DISPLAY ASSEMBLY |
Temporarily replace the television display assembly with a new or normally functioning one (Click here).
Check that the mute signal circuit functioning normally.
|
| ||||
| OK | ||
| ||