Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR

COMPRESSOR > INSPECTION

for Preparation Click here



1. INSPECT MAGNET CLUTCH ASSEMBLY


I104344E01
  1. Check the magnet clutch operation.

    1. Confirm that the magnet clutch hub and magnet clutch rotor lock when the battery positive lead is connected to terminal 3 of the magnet clutch, and the negative lead is connected to the ground wire.
      If the operation is not as specified, replace the magnet clutch assembly.

  1. Measure the resistance.

  1. Measure the resistance between terminals 1 and 2.

    Standard resistance:
    165 to 205 Ω at 25°C (77°F)
    If the resistance is not as specified, replace the cooler compressor assembly.