Home › Drivetrain ยท DRIVE SHAFT / PROPELLER SHAFT › REAR DRIVE SHAFT ASSEMBLY

REAR DRIVE SHAFT ASSEMBLY > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR DRIVE SHAFT INBOARD JOINT SHAFT SNAP RING


    C057543
  1. Using a screwdriver, remove the inboard joint shaft snap ring.

    NOTICE:
    Do not damage the spline of the inboard joint shaft.



2. REMOVE REAR DRIVE SHAFT INBOARD JOINT BOOT CLAMP
  1. Using a side cutter, cut the inboard joint boot clamp and remove it.



3. REMOVE REAR DRIVE SHAFT NO. 2 INBOARD JOINT BOOT CLAMP
  1. Using a side cutter, cut the No. 2 inboard joint boot clamp and remove it.



4. DISCONNECT REAR DRIVE SHAFT INBOARD JOINT BOOT


    C177089E02
  1. Disconnect the inboard joint boot from the inboard joint shaft.



5. REMOVE REAR DRIVE SHAFT INBOARD JOINT SHAFT ASSEMBLY


    C115632E04
  1. Place matchmarks on the inboard joint shaft and outboard joint shaft.

    NOTICE:
    Do not punch the marks.

  1. Using a screwdriver, remove the snap ring from the inboard joint shaft.

  1. Remove the inboard joint shaft from the outboard joint shaft.



    C115633E06
  1. Place matchmarks on the outboard joint shaft, inner race and cage.

    NOTICE:
    Do not punch the marks.

  1. Remove the 6 balls.

  1. Slide the cage to the outboard joint side.



    C158392
  1. Using a snap ring expander, remove the snap ring.



    C158393
  1. Using a brass bar and hammer, tap out the inner race.

    NOTICE:
    Be careful not to damage the inner race.

  1. Remove the cage.



6. REMOVE REAR DRIVE SHAFT INBOARD JOINT BOOT
  1. Remove the inboard joint boot from the outboard joint shaft.



7. REMOVE REAR DRIVE SHAFT OUTBOARD JOINT BOOT CLAMP
  1. Using a side cutter, cut the outboard joint boot clamp and remove it.



8. REMOVE REAR DRIVE SHAFT NO. 2 OUTBOARD JOINT BOOT CLAMP
  1. Using a side cutter, cut the No. 2 outboard joint boot clamp and remove it.



9. REMOVE REAR DRIVE SHAFT OUTBOARD JOINT BOOT
  1. Remove the outboard joint boot from the outboard joint shaft.



10. REMOVE REAR DRIVE SHAFT DUST COVER


    C124194E02
  1. Using SST and a press, press out the dust cover from the inboard joint shaft.

    SST
    09950-00020  

    NOTICE:
    Do not drop the inboard joint shaft.



11. REMOVE REAR DRIVE SHAFT DUST SEAL


    C124193E02
  1. Using SST and a press, press out the dust seal from the outboard joint shaft assembly.

    SST
    09950-00020  

    NOTICE:
    Do not drop the outboard joint shaft assembly.