FRONT AXLE HUB > DISASSEMBLY |
| 1. REMOVE FRONT WHEEL ADJUSTING NUT (for 2WD) |
![]() |
Using SST and a hammer, release the staked part of the adjusting nut.
Install a nut to the front axle hub, and fix it in a vise.
![]() |
Using SST and the L-type handle, remove the front wheel adjusting nut.
| 2. REMOVE FRONT AXLE WITH ABS ROTOR BEARING ASSEMBLY |
![]() |
Gently fix the front axle hub in a vise.
Using SST, remove the bearing.
![]() |
If part of the bearing remains in the front axle hub, use SST to remove it.
| 3. REMOVE FRONT AXLE HUB OIL SEAL |
![]() |
Using a screwdriver, remove the front axle hub oil seal.
| 4. REMOVE PLUG (for 2WD) |
![]() |
Using a screwdriver and hammer, remove the plug.