Home › Drivetrain ยท AXLE AND DIFFERENTIAL › FRONT AXLE HUB

FRONT AXLE HUB > REASSEMBLY

for Preparation Click here


NOTICE:
Do not allow foreign matter, etc. to contact the ABS rotor bearing.



1. INSTALL PLUG (for 2WD)


    C119749E01
  1. Using the SST and a hammer, install a new plug.

    SST
    09950-60010   (09951-00450)
    09950-70010   (09951-07100)



2. INSTALL FRONT AXLE HUB OIL SEAL


    C178876E01
  1. Using SST and a press, press in a new oil seal.

    SST
    09608-36010  
    09950-70010   (09951-07100)

    NOTICE:
    Do not damage the oil seal.



3. INSTALL FRONT AXLE WITH ABS ROTOR BEARING ASSEMBLY


    C178875E01
  1. Using SST and a press, press in a new bearing.

    SST
    09608-32010  

    NOTICE:
    1. Insert 4 bolts into the bearing before installing the axle hub.
    2. Make sure to securely fit the bearing to the axle hub.



4. INSTALL FRONT WHEEL ADJUSTING NUT (for 2WD)


    C180047E01
  1. Using SST, install a new adjusting nut.

    SST
    09602-60010  

    Torque:
    382 N*m{ 3895 kgf*cm , 282 ft.*lbf }