CONDENSER > REMOVAL |
| 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM |
Start up the engine.
Switch A/C ON.
Turn the blower switch to ON.
Operate the cooler compressor with an engine speed of approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the remaining compressor oil from each component, in the cooler compressor.
Stop the engine.
![]() |
Remove the caps from the service valves on the refrigerant line.
Connect the refrigerant recovery unit.
Recover the refrigerant from the air conditioning system using a refrigerant recovery unit.
| 2. REMOVE RADIATOR ASSEMBLY |
Remove the radiator assembly (Click here).
| 3. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE |
![]() |
Remove the bolt and disconnect the discharge hose from the cooler condenser.
Remove the O-ring from the discharge hose.
| 4. DISCONNECT AIR CONDITIONING TUBE ASSEMBLY |
![]() |
Remove the 2 bolts and air conditioning tube from the cooler condenser.
Remove the O-ring from the air conditioning tube.
| 5. REMOVE COOLER CONDENSER ASSEMBLY |
![]() |
Remove the 2 bolts.
Remove the cooler condenser, as shown in the illustration.