Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

DTC    B15C0    Short in GPS Antenna

DTC    B15C1    Open in GPS Antenna

for Preparation Click here


DESCRIPTION

These DTCs are stored when a malfunction occurs in the navigation antenna assembly.

DTC Code
DTC Detection Condition
Trouble Area
B15C0
Navigation antenna error
  1. Navigation antenna assembly
  2. Navigation receiver assembly
B15C1
Error of the power source to the navigation antenna

INSPECTION PROCEDURE

1.CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    No DTCs are output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK CONNECTION OF NAVIGATION ANTENNA ASSEMBLY
  1. Check if the navigation antenna assembly is securely connected to the navigation receiver assembly.

    OK:
    Navigation antenna assembly is securely connected.



NG
SECURELY CONNECT NAVIGATION ANTENNA ASSEMBLY
OK


3.INSPECT NAVIGATION ANTENNA ASSEMBLY


    E285960E01
  1. Remove the navigation antenna assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.
    Standard Resistance 
    Tester Connection
    Condition
    Specified Condition
    1 - 1a
    Always
    50 to 500 Ω



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)