DTC 01-D6 No Master |
DTC 01-D7 Connection Check Error |
| DTC Code | DTC Detection Condition | Trouble Area |
| 01-D6*1 | When either of the following conditions is met:
|
|
| 01-D7*2 | When either of the following conditions is met:
|
| 1.CHECK RADIO RECEIVER POWER SOURCE CIRCUIT |
Refer to Radio Receiver Power Source Circuit (Click here).
| NEXT | |
| 2.IDENTIFY THE COMPONENT WHICH HAS STORED THIS CODE |
Enter the diagnostic mode.

Press the preset switch "3" to change to "Detailed Information Mode".
Identify the component which has stored this code.
| Component | Physical Address |
| Stereo component amplifier | 440 |
| NEXT | |
| 3.CHECK POWER SOURCE CIRCUIT OF COMPONENT WHICH HAS STORED THIS CODE |
Inspect the power source circuit of the component which has stored this code.
| Component | Proceed to |
| Stereo component amplifier | Stereo Component Amplifier Power Source Circuit (Click here) |
| NEXT | |
| 4.INSPECT RADIO RECEIVER ASSEMBLY |
![]() |
Remove the radio receiver assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 5 (ATX+) - 15 (ATX-) | Always | 60 to 80 Ω |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - COMPONENT WHICH HAS STORED THIS CODE) |

Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the radio receiver assembly and the component which has stored this code.
Disconnect all connectors between the radio receiver assembly and the component which has stored this code.
Check for an open or short in the AVC-LAN circuit between the radio receiver assembly and the component which has stored this code.
|
| ||||
| OK | |
| 6.REPLACE COMPONENT WHICH HAS STORED THIS CODE |
Replace the component which has stored this code with a normal one and check if the same problem occurs again.
|
| ||||
| OK | ||
| ||