Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

DTC    01-DD    Master Reset

DTC    01-E1    Voice Processing Device ON Error

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
01-DD*1
The device that should be the master has been disconnected after engine start.
  1. Radio receiver power source circuit
  1. AVC-LAN circuit between the radio receiver assembly and the component which has stored this code
  1. Radio receiver assembly
  1. Component which has stored this code
01-E1*2
The AMP device records that the AMP output does not function even while the source device operates.

HINT:
*1: This code may be stored if the engine is started and the ignition switch is turned to start position again.
*2: Even if no fault is present, this trouble code may be stored depending on the battery condition or engine start voltage.

NOTICE:
  1. Before starting troubleshooting, be sure to clear DTCs to clear codes stored due to the reasons described in Hint above. Then, check for DTCs and troubleshoot according to the output DTCs.
  1. The radio receiver assembly is the master unit.
  1. Be sure to clear and recheck DTCs after the inspection is completed to confirm that no DTCs are output.


INSPECTION PROCEDURE

NOTICE:
Be sure to read Description before performing the following procedures.

1.CHECK RADIO RECEIVER POWER SOURCE CIRCUIT
  1. Refer to Radio Receiver Power Source Circuit (Click here).

    HINT:
    If the power source circuit is operating normally, proceed to the next step.


NEXT


2.INSPECT RADIO RECEIVER ASSEMBLY


    E265526E01
  1. Remove the radio receiver assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    5 (ATX+) - 15 (ATX-)
    Always
    60 to 80 Ω



NG
REPLACE RADIO RECEIVER ASSEMBLY (Click here)
OK


3.IDENTIFY COMPONENT WHICH HAS STORED THIS CODE


  1. Enter the diagnostic mode.


    E146440E04

  1. Press the preset switch "3" to change to "Detailed Information Mode".

  1. Identify the component which has stored this code.
    Component Table 
    Component
    Physical Address
    Stereo component amplifier
    440

HINT:
  1. "440 (stereo component amplifier)" is the component which has stored this code in the example shown in the illustration.
  2. For details of the DTC display, refer to "DTC Check/Clear" (Click here).


NEXT


4.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - COMPONENT WHICH HAS STORED THIS CODE)

E265527E01

HINT:
For details of the connectors, refer to "Terminals of ECU" (Click here).

  1. Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the radio receiver assembly and the component which has stored this code.

    1. Disconnect all connectors between the radio receiver assembly and the component which has stored this code.

    2. Check for an open or short in the AVC-LAN circuit between the radio receiver assembly and the component which has stored this code.

      OK:
      There is no open or short circuit.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE RADIO RECEIVER ASSEMBLY
  1. Replace the radio receiver assembly (Click here).

    OK:
    Same problem does not occur.



NG
REPLACE COMPONENT WHICH HAS STORED THIS CODE
OK

END