Home › Brake › BRAKE (REAR) › REAR BRAKE

REAR BRAKE > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. DRAIN BRAKE FLUID

NOTICE:
Wash brake fluid off immediately if it is spilled on any painted surface.



3. DISCONNECT REAR FLEXIBLE HOSE LH


    C180573
  1. Remove the union bolt and gasket, and then disconnect the flexible hose from the rear disc brake cylinder. Use a container to catch brake fluid as it drains out.



4. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY LH


    C180572
  1. Remove the 2 slide pins.

  1. Remove the cylinder from the rear disc brake cylinder mounting.



5. REMOVE REAR DISC BRAKE PAD
  1. Remove the 2 brake pads from the rear disc brake cylinder mounting.



6. REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM
  1. Remove the anti-squeal shim from each disc brake pad.



7. REMOVE PAD WEAR INDICATOR PLATE
  1. Remove the pad wear indicator plate from the inner disc brake pad.



8. REMOVE REAR DISC BRAKE PAD SUPPORT PLATE

NOTICE:
  1. The pad support plates are attached to the rear disc brake cylinder mounting with double-sided tape. When removing the brake pads, make sure the pad support plates are not detached. If the pad support plates are not detached, they can be reused. If they are detached, replace the pad support plates with new ones.
  2. If the pad support plates are removed during maintenance of parts, replace them with new ones.

  1. Remove the 4 pad support plates from the rear disc brake cylinder mounting.



9. REMOVE REAR DISC BRAKE CYLINDER MOUNTING LH


    C180571
  1. Remove the 2 bolts and rear disc brake cylinder mounting.

    NOTICE:
    If the pad support plates are removed during maintenance of parts, replace them with new ones.

  1. Remove the 2 boots from the rear disc brake cylinder mounting.



10. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG


11. REMOVE REAR DISC


    C178157E02
  1. Put matchmarks on the rear disc and axle hub if planning to reuse the disc.



    C155453
  1. Turn the shoe adjuster until the disc turns freely, and then remove the disc.