AUDIO AND VISUAL SYSTEM > AVC-LAN Circuit |
| 1.INSPECT RADIO RECEIVER ASSEMBLY |
![]() |
Remove the radio receiver assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 5 (ATX+) - 15 (ATX-) | Always | 60 to 80 Ω |
| 9 (TXM+) - 10 (TXM-)* | Always | 60 to 80 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - COMPONENT WHICH HAS STORED THIS CODE) |

Referring to the AVC-LAN wiring diagram below, check all AVC-LAN circuits.
Disconnect all connectors in all AVC-LAN circuits.
Check for an open or short in all AVC-LAN circuits.
|
| ||||
| OK | ||
| ||