Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > AVC-LAN Circuit

for Preparation Click here


DESCRIPTION

Each unit of the audio system connected to the AVC-LAN (communication bus) transfers the signal of each switch by communication.
When a short to +B or short to ground occurs in this AVC-LAN, the audio system will not function normally as the communication is discontinued.

INSPECTION PROCEDURE

1.INSPECT RADIO RECEIVER ASSEMBLY


    E265526E01
  1. Remove the radio receiver assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    5 (ATX+) - 15 (ATX-)
    Always
    60 to 80 Ω



NG
REPLACE RADIO RECEIVER ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - COMPONENT WHICH HAS STORED THIS CODE)

E265527E01

HINT:
For details of the connectors, refer to "Terminals of ECU" (Click here).

  1. Referring to the AVC-LAN wiring diagram below, check all AVC-LAN circuits.

    1. Disconnect all connectors in all AVC-LAN circuits.

    2. Check for an open or short in all AVC-LAN circuits.

      OK:
      There is no open or short circuit.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)