VANE PUMP > REASSEMBLY |
| 1. INSTALL VANE PUMP HOUSING OIL SEAL |
![]() |
Coat the lip of a new oil seal with power steering fluid.
Using SST and a press, press in the oil seal.
| 2. INSTALL VANE PUMP SHAFT SUB-ASSEMBLY WITH PULLEY |
![]() |
Coat the inside surface of the bushing in the vane pump front housing with power steering fluid.
Gradually insert the vane pump shaft sub-assembly with pulley.
| 3. INSTALL VANE PUMP FRONT SIDE PLATE |
![]() |
Coat a new O-ring with power steering fluid and install it into the front housing.
![]() |
Coat a new O-ring with power steering fluid and install it onto the front side plate.
![]() |
Align the notch of the front side plate with the notch of the front housing, and install the front side plate.
| 4. INSTALL VANE PUMP CAM RING |
![]() |
Align the notch of the cam ring with the notch of the front side plate, and install the cam ring with the inscribed mark facing upward.
| 5. INSTALL VANE PUMP ROTOR |
![]() |
Install the vane pump rotor.
Coat the 10 vane pump plates with power steering fluid.
![]() |
Install the vane pump plates with the round end facing outward.
| 6. INSTALL VANE PUMP SHAFT SNAP RING |
![]() |
Using a screwdriver and snap ring expander, install a new shaft snap ring onto the vane pump shaft.
| 7. INSTALL VANE PUMP REAR HOUSING |
![]() |
Coat a new O-ring with power steering fluid and install it onto the rear housing.
![]() |
Align the straight pin of the rear housing with the notches of the cam ring, front side plate, and front housing.
![]() |
Install the rear housing with the 4 bolts.
| 8. INSPECT TOTAL PRELOAD |
Check that the pump rotates smoothly without abnormal noise.
Temporarily install the service bolt.
| Thread diameter | Thread pitch | Bolt length |
| 10 mm (0.394 in.) | 1.25 mm (0.0492 in.) | 50 mm (1.97 in.) |
![]() |
Using a torque wrench, measure the pumps rotating torque.
| 9. INSTALL POWER STEERING SUCTION PORT UNION |
Coat a new O-ring with power steering fluid and install it to the suction port union.
![]() |
Install the suction port union to the vane pump with the bolt.