POWER STEERING SYSTEM > EPS Warning Light Circuit |

| 1.INSPECT CAN COMMUNICATION SYSTEM |
Check if the CAN communication system DTC is output (Click here).
| Result | Proceed to |
| DTC not output | A |
| DTC output | B |
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BATTERY) |
![]() |
Disconnect the power steering ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| H38-6 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H38-2 (GND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK EPS WARNING LIGHT USING INTELLIGENT TESTER (COMBINATION METER) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and the intelligent tester on.
Perform the Active Test of the combination meter (meter CPU) using the intelligent tester (Click here).
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Indicat. EPS | EPS warning light | ON or OFF | Perform the test with the vehicle stopped and engine idling |
Check that the EPS warning light brinks or not in the combination meter using the intelligent tester.
|
| ||||
| OK | ||
| ||