Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH

HAZARD WARNING SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HAZARD WARNING SWITCH


E136319E02
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      1 - 4
      OFF
      10 kΩ or higher
      1 - 4
      ON
      Below 1 Ω

      If the result is not as specified, replace the hazard warning signal switch.

  1. Check the illumination operation.

    1. Connect the positive (+) battery lead to terminal 3 and the negative (-) battery lead to terminal 2, and then check that the illumination illuminates.

      OK:
      Illumination illuminates.

      If the illumination does not illuminate, replace the hazard warning signal switch.