Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DIAGNOSIS
  1. If the skid control ECU detects a malfunction, the ABS and brake warning lights and the slip indicator light come on to warn the driver.

    HINT:
    1. The DTCs are simultaneously stored in the memory. The DTCs can be read by connecting SST between terminals TC and CG of the DLC3 and observing the blinking of the ABS warning light and slip indicator light, or by connecting the intelligent tester.
    2. This system has a signal check function (Click here).


WARNING LIGHT AND INDICATOR LIGHT BULB CHECK
  1. Release the parking brake lever.

    CAUTION:
    When releasing the parking brake, set the chocks to hold the vehicle for safety.

    HINT:
    When the parking brake is applied or the level of brake fluid is low, the brake warning light comes on.

  2. When the ignition switch is turned ON, check that the ABS and brake warning lights, and the VSC OFF, TRC OFF and slip indicator lights come on for approximately 3 seconds.

    HINT:
    If the warning light and indicator light check result is not normal, proceed to troubleshooting for the ABS and brake warning light circuits, and the VSC OFF, TRC OFF and slip indicator light circuits.
    If the indicator remains on or does not come on, proceed to troubleshooting for the light circuit below.

    Trouble Area
    See Procedure
    ABS warning light circuit (Remains on)
    Click here
    ABS warning light circuit (Does not come on)
    Click here
    Brake warning light circuit (Remains on)
    Click here
    Brake warning light circuit (Does not come on)
    Click here
    VSC OFF indicator light circuit (Remains on)
    Click here
    VSC OFF indicator light circuit (Does not come on)
    Click here
    TRC OFF indicator light circuit (Remains on)
    Click here
    TRC OFF indicator light circuit (Does not come on)
    Click here
    Slip indicator light circuit (Remains on)
    Click here
    Slip indicator light circuit (Does not come on)
    Click here