DTC B2795 Unmatched Key Code |
| DTC No. | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
| B2795 | A key with a different vehicle serial number is inserted into the ignition key cylinder (1 trip detection logic*). |
| Insert the key into the ignition key cylinder. |
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
| Engine cannot be started | - |
| DTC No. | Data List and Active Test |
| B2795 | - |
| 1.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 2.CHECK FOR DTC |
Insert and remove each registered key one at a time, and check for DTCs each time (Click here).
| Result | Proceed to |
| DTC B2795 is not output | A |
| DTC B2795 is output for all of the keys | B |
| DTC B2795 is output for any of the keys | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 3.CHECK OPERATION (IG ON) |
Check that the ignition switch can be turned to ON using the key for which the DTC was stored.
|
| ||||
| OK | |
| 4.REREGISTRATION |
Clear the DTCs (Click here).
Reregister the key ID code with the transponder key ECU assembly.
|
| ||||
| OK | ||
| ||