DTC B2796 No Communication in Immobiliser System |
| DTC No. | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
| B2796 | The key ID code cannot be transmitted to the transponder key ECU assembly (1 trip detection logic*). |
| Insert the key into the ignition key cylinder |
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
| Engine cannot be started | - |
| DTC No. | Data List and Active Test |
| B2796 | - |

| 1.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 2.CHECK FOR DTC |
Insert and remove each registered key one at a time, and check for DTCs each time (Click here).
| Result | Proceed to |
| DTC B2796 is not output | A |
| DTC B2796 is output for all of the keys | B |
| DTC B2796 is output for any of the keys | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 3.REPLACE TRANSPONDER KEY ECU ASSEMBLY |
Replace the transponder key ECU assembly with a new one.
| NEXT | |
| 4.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 5.CHECK FOR DTC |
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 6.REPLACE KEY |
Replace the key for which the DTC was stored.
| NEXT | |
| 7.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 8.CHECK FOR DTC |
Check for DTCs (Click here).
| Result | Proceed to |
| B2796 is not output | A |
| B2796 is output | B |
|
| ||||
| A | ||
| ||