ENGINE IMMOBILISER SYSTEM > DATA LIST / ACTIVE TEST |
| DATA LIST |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Immobiliser / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| D Door Courtesy SW | Driver side courtesy switch signal / ON or OFF | ON: Driver side door open OFF: Driver side door closed | - |
| Key SW | Unlock warning switch signal / ON or OFF | ON: Key in ignition key cylinder OFF: No key in ignition key cylinder | - |
| IG SW | Ignition switch signal / ON or OFF | ON: Ignition switch ON or engine started OFF: Ignition switch ACC or off | - |
| Immobiliser | Immobiliser system status / Set or Unset | Set: No key in ignition key cylinder, or 20 sec. elapsed after turning the ignition switch to ACC or off Unset: Key in ignition key cylinder | - |
| Response | Transponder chip data / NG or OK | NG: Data error OK: Data OK | - |
| Frame Error | Transponder chip data / NG or OK | NG: Data error OK: Data OK | - |
| Different Serial Number | Transponder chip data / NG or OK | NG: Data error OK: Data OK | - |
| Different Encrypt Code | Transponder chip data / NG or OK | NG: Data error OK: Data OK | - |
| Abnormal Status | Transponder chip data / NG or OK | NG: Data error OK: Data OK | - |
| Bcc Malfunction | Transponder chip data / NG or OK | NG: Incorrect data being sent OK: Correct data being sent | - |
| Sub Key | Sub key ID code signal / Reg or Unreg | Reg: Registered sub key ID code sent Unreg: Unmatching sub key ID code sent | - |
| Master Key | Master key ID code signal / Reg or Unreg | Reg: Registered master key ID code sent Unreg: Unmatching master key ID code sent | - |
| Transponder S-Code | Number of registered sub key / min. 0, max. 15 | Number of registered sub key | - |
| Transponder M-Code | Number of registered master key / min. 0, max. 15 | Number of registered master key | - |
| Reg Code Space Full | Memory space for key codes registration / NOT FULL or FULL | NOT FULL: Key code registration possible FULL: Key code registration not possible | - |
| +B | Power source / Break or Normal | Break: Power source open Normal: Power source normal | - |
| Antenna Coil Status | Transponder key coil condition / Normal or Fail | Normal: Antenna coil normal Fail: Antenna coil malfunctioning | - |
| EEPROM Status | EEPROM status / NG or OK | NG: EEPROM malfunctioning OK: EEPROM normal | - |
| E/G Start Permission | Engine start permission / NG or OK | NG: Engine start not permitted OK: Engine start permitted | - |
| Immobi ECU Comm Spd | Immobiliser ECU communication speed / Unknown, 50bps, 200bps or No Res | Unknown: ECU communication speed unknown 50bps: ECU communication speed 50 bps 200bps: ECU communication speed 200 bps No Res: No ECU communication response | - |
| The Number of DTCs | Number of DTCs / Min.: 0, Max.: 255 | Number of stored DTCs | - |

Enter the following menus: Powertrain / Engine and ECT / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Immobiliser Fuel Cut | Status of immobiliser system fuel cut / ON or OFF | ON: Immobiliser fuel cut on OFF: Immobiliser fuel cut off | - |
| ACTIVE TEST |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Immobiliser / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Security Indicator | Security indicator light | ON/OFF | - |