Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER

BRAKE BOOSTER > REMOVAL

for Preparation Click here


NOTICE:
Release the vacuum from the booster by depressing the brake pedal several times. Then remove the brake master cylinder sub-assembly from the brake booster assembly.



1. DRAIN BRAKE FLUID

NOTICE:
  1. Immediately wash off any brake fluid that comes into contact with any painted surfaces.
  2. Attempting to disengage both front and rear clips at the same time may cause the V-bank cover sub-assembly to break.



2. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
  1. Remove the brake master cylinder sub-assembly (Click here).



3. DISCONNECT VACUUM HOSE ASSEMBLY
  1. Slide the clip and disconnect the vacuum hose from the check valve.



4. DISCONNECT BRAKE BOOSTER CONNECTOR
  1. Disconnect the 2 brake booster connectors from the brake booster.



5. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.



6. REMOVE COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



7. REMOVE INSTRUMENT SIDE PANEL LH


    B226739
  1. Using a moulding remover, detach the 7 claws and remove the side panel.



8. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B192511
  1. Detach the 3 claws.

  1. Disconnect the hood lock control cable and remove the hood lock control lever sub-assembly.



9. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


B229064
  1. Remove the 2 <A> bolts.

  1. Detach the 9 clips and claw.



    B163883
  1. Detach the 2 claws and remove the sensor.

  1. Remove the finish panel and then disconnect the connectors.



10. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY


    B225997
  1. Remove the 4 bolts and remove the instrument panel airbag.

  1. Detach the 2 claws and disconnect the DLC3.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



11. REMOVE PUSH ROD PIN
  1. Remove the clip and push rod pin.



12. REMOVE BRAKE BOOSTER ASSEMBLY


    C154474
  1. Remove the 4 nuts, and then pull out the brake booster.

  1. Remove the gasket from the brake booster.

  1. Loosen the lock nut and then remove the clevis.



13. REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY