Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

POWER STEERING SYSTEM > VFC Power Steering Solenoid Circuit

for Preparation Click here


DESCRIPTION

This circuit supplies electric power to the power steering solenoid valve.
The power steering ECU controls the output current to the power steering solenoid valve in accordance with the steering angle signal, the steering zero point memory, the vehicle speed signal, and the engine speed signal, adjusting the amount of power steering assist.

WIRING DIAGRAM


C202751E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (POWER STEERING SOLENOID VALVE - ECU)
C179928E01
  1. Disconnect the power steering ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H38-4 (SOF-) - H38-9 (SOF+)
    20°C (68°F)
    6.7 to 7.3 Ω
    H38-4 (SOF-) - Body ground
    Always
    10 kΩ or higher
    H38-9 (SOF+) - Body ground
    Always
    10 kΩ or higher



NG
Go to step 3
OK


2.INSPECT POWER STEERING SOLENOID VALVE
C179951E02
  1. Disconnect the power steering solenoid valve connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (SOF-) - 2 (SOF+)
    20°C (68°F)
    6.7 to 7.3 Ω

  1. Connect the battery positive (+) lead with a 21 W bulb to terminal 2 (SOF+) and the negative (-) lead to terminal 1 (SOF-) of the solenoid valve connector. Then check that the valve moves and makes an operating noise.

    OK:
    Valve moves and makes an operating noise.



NG
REPLACE VANE PUMP ASSEMBLY (Click here)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

3.INSPECT POWER STEERING SOLENOID VALVE
C179951E02
  1. Disconnect the power steering solenoid valve connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (SOF-) - 2 (SOF+)
    20°C (68°F)
    6.7 to 7.3 Ω

  1. Connect the battery positive (+) lead with a 21 W bulb to terminal 2 (SOF+) and the negative (-) lead to terminal 1 (SOF-) of the solenoid valve connector. Then check that the valve moves and makes an operating noise.

    OK:
    Valve moves and makes an operating noise.



NG
REPLACE VANE PUMP ASSEMBLY (Click here)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR