Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1203/53    ECM Communication Circuit Malfunction

for Preparation Click here


DESCRIPTION

A new skid control ECU is supplied without engine variation data. Until it is recognized by the ECU, DTC C1203/53 remains stored. By entering test mode, recognition of engine variation data is automatically conducted, and DTC C1203/53 is cleared automatically.

DTC Code
DTC Detection Condition
Trouble Area
C1203/53
When all of following conditions detected:
  1. Engine variation data from ECM does not match one in skid control ECU non-volatile memory.
  2. DTC U0073/94 not detected.
  3. DTC U0100/65 not detected.
  1. Test mode not performed
  2. VSC actuator (skid control ECU)

INSPECTION PROCEDURE

NOTICE:
When replacing the VSC actuator assembly, perform zero point calibration (Click here).

1.PERFORM TEST MODE INSPECTION
  1. Perform a TEST MODE inspection (Click here).


NEXT


2.RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Start the engine.

  1. Check if the same DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (Click here)
A

REPLACE VSC ACTUATOR ASSEMBLY (Click here)