Home › Suspension › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM (w/o AVS)

AIR SUSPENSION SYSTEM (w/o AVS) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
*: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.CHECK AND CLEAR DTC*
      1. Check if any DTCs are output (Click here).

        HINT:
        The suspension control ECU of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.

        Result 
        Result
        Proceed to
        CAN DTC not output
        A
        CAN DTC output
        B



      B.
      GO TO CAN COMMUNICATION SYSTEM (Click here)
      A


      4.CHECK AND CLEAR DTC*
      1. Check for a DTC (Click here).


      NEXT


      5.PROBLEM SYMPTOM CONFIRMATION
      1. Measure the resistance according to the value(s) in the table below.
        Result 
        Result
        Proceed to
        Symptom Does Not Occur
        A
        Symptom Occurs
        B



      B.
      Go to step 7
      A


      6.SYMPTOM SIMULATION

        NEXT


        7.CHECK DTC*
        1. Check for a DTC (Click here).
          Result 
          Result
          Proceed to
          DTC not output
          A
          DTC output
          B



        B.
        Go to step 9
        A


        8.PROBLEM SYMPTOMS TABLE
        1. Refer to the Problem Symptoms Table (Click here).


        NEXT


        9.DTC CHART
        1. Refer to the Diagnostic Trouble Code Chart (Click here).


        NEXT


        10.CIRCUIT INSPECTION*
        1. Inspect the circuit.


        NEXT


        11.IDENTIFICATION OF PROBLEM

          NEXT


          12.REPAIR OR REPLACE

            NEXT


            13.CONFIRMATION TEST

              NEXT

              END