DTC C1782 Power Source Voltage Malfunction |
| DTC Code | Detection Condition | Trouble Area |
| C1782 | Terminal IG or B voltage is 10 V or less, or 16 V or more for 0.5 seconds |
|

| 1.READ VALUE USING INTELLIGENT TESTER (POWER SOURCE VOLTAGE) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON, and turn the intelligent tester on.
Enter the following menus: Chassis / Air suspension / Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| +B Power Source Voltage | ECU power supply voltage / min.: 0 V, max.: 25.5 V | Actual battery power supply voltage: 11 to 14 V | - |
| IG Power Source Voltage | ECU power supply voltage / min.: 0 V, max.: 25.5 V | Actual ECU power supply voltage: 11 to 14 V | - |
| Result | Proceed to |
| NG | A |
| OK (When troubleshooting according to the Problem Symptoms Table) | B |
| OK (When troubleshooting according to the DTC Chart) | C |
|
| ||||
|
| ||||
| A | |
| 2.INSPECT FUSE (AIR SUS, AIR SUS NO. 2, AIR SUS IG) |
![]() |
Remove the AIR SUS and AIR SUS No. 2 fuses from the engine room relay block.
Remove the AIR SUS IG fuse from the cowl side junction block LH.
Measure the resistance of the AIR SUS, AIR SUS No. 2 and AIR SUS IG fuses.
| Fuse | Condition | Specified Condition |
| AIR SUS | Always | Below 1 Ω |
| AIR SUS No. 2 | Always | Below 1 Ω |
| AIR SUS IG | Always | Below 1 Ω |
Reinstall the AIR SUS, AIR SUS No. 2 and AIR SUS IG fuses.
|
| ||||
| OK | |
| 3.CHECK BATTERY VOLTAGE |
![]() |
Disconnect the O16 ECU connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| O16-3 (B) - Body ground | Always | 11 to 14 V |
| O16-1 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | |
| 4.CHECK FOR DTC |
Clear the DTC (Click here).
Check for DTC (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | ||
| ||