Home › Suspension › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM (w/o AVS)

DTC    U0100    Lost Communication with ECM / PCM "A"

DTC    U0122    Lost Communication with Vehicle Dynamics Control Module

for Preparation Click here


DESCRIPTION

The suspension control ECU inputs signals from the skid control ECU and ECM via CAN communication. When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system first.

DTC Code
Detection Condition
Trouble Area
U0100
While driving at 30 km/h (19 mph), CAN communication between suspension control ECU and ECM stops for 3 seconds or more.
  1. CAN communication line
  2. ECM
  3. Suspension control ECU
U0122
CAN communication between suspension control ECU and Skid control ECU stops for 3 seconds or more.
  1. CAN communication line
  2. Skid control ECU
  3. Suspension control ECU

INSPECTION PROCEDURE

1.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Perform a road test.

  1. Check if DTC U0100 or U0122 are output (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B

    HINT:
    If a CAN communication malfunction DTC and a related sensor malfunction DTC are output at the same time, the CAN communication malfunction must be repaired before troubleshooting the sensor malfunction DTC.



B
USE SIMULATION METHOD TO CHECK (Click here)
A

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)