Home › Suspension › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM (w/ AVS)

DTC    U0100    Lost Communication with ECM / PCM "A"

DTC    U0122    Lost Communication with Vehicle Dynamics Control Module

DTC    U0124    Lost Communication with Lateral Acceleration Sensor Module

DTC    U0126    Lost Communication with Steering Angle Sensor Module

DTC    U0140    Lost Communication with Body Control Module

for Preparation Click here


DESCRIPTION

The suspension control ECU inputs signals from the skid control ECU and ECM via CAN communication. When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system first.

DTC Code
Detection Condition
Trouble Area
U0100
While driving at 30 km/h (19 mph), CAN communication between suspension control ECU and ECM stops for 3 seconds or more.
  1. CAN communication line
  2. ECM
  3. Suspension control ECU
U0122
CAN communication between suspension control ECU and Skid control ECU stops for 3 seconds or more.
  1. CAN communication line
  2. Skid control ECU
  3. Suspension control ECU
U0124
CAN communication between suspension control ECU and yaw rate and acceleration sensor stops for 3 seconds or more.
  1. CAN communication line
  2. Yaw rate and acceleration sensor
  3. Suspension control ECU
U0126
CAN communication between suspension control ECU and steering angle sensor stops for 3 seconds or more.
  1. CAN communication line
  2. Steering angle sensor
  3. Suspension control ECU
U0140
CAN communication between suspension control ECU and main body ECU stops for 3 seconds or more.
  1. CAN communication line
  2. Main body ECU (Cowl side junction block LH)
  3. Suspension control ECU

INSPECTION PROCEDURE

NOTICE:
After replacing the suspension control ECU, perform registration (Click here).

1.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Perform a road test.

  1. Check if DTC U0100, U0122, U0124, U0126 or U0140 are output (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B

    HINT:
    If a CAN communication malfunction DTC and a related sensor malfunction DTC are output at the same time, the CAN communication malfunction must be repaired before troubleshooting the sensor malfunction DTC.



B
USE SIMULATION METHOD TO CHECK (Click here)
A

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)