Component
| Function
|
Absorber Control Switch
| Selects the damping force of shock absorbers (SPORT, NORMAL, COMFORT).
|
Front Acceleration Sensor (LH, RH)
| Detects the front right or left body vertical accelerated motions.
|
Front Suspension Control Actuator (LH, RH)
| Changes the damping force of the front shock absorber.
|
Rear Suspension Control Actuator (Rear Shock Absorber Assembly) (LH, RH)
| Changes the damping force of the rear shock absorber.
|
Height Control Mode Select Switch
| - Used to select vehicle height control mode (Auto/Manual).
- Used to operate or stop auto leveling control.
|
Height Control Switch
| - Auto mode: Used to select vehicle height (HIGH, NORMAL, LOW).
- Manual mode: Used to select vehicle height optionally.
|
Height Control Sensor (LH, RH)
| Converts the vertical change of the rear vehicle height, in proportion to the standard, to signals and detects vehicle height.
|
Height Control Indicator Light (Combination Meter)
| - Auto mode: Target vehicle height is displayed (HIGH, NORMAL, LOW).
- Manual mode: Current vehicle height is displayed (HIGH, NORMAL, LOW).
|
Height Control Manual Indicator Light (Combination Meter)
| - Comes on during manual mode.
- Blinks when the suspension control ECU detects a system malfunction.
- Blinks during test mode.
|
Pneumatic Cylinder Assembly (LH, RH)
| Supports the vehicle body and adjusts the vehicle height.
|
Compressor/Height Control Dryer (No. 1 Height Control Compressor)
| - The compressor generates compressed air that is necessary to raise vehicle height and supplies it to the pneumatic cylinder assemblies.
- The dryer removes moisture from the compressed air.
|
Exhaust Solenoid Valve (No. 1 Height Control Compressor)
| Discharges compressed air from the pneumatic cylinder assemblies to lower the vehicle.
|
Leveling Solenoid Valve (No. 2 Height Control Valve Sub-assembly)
| Adjusts the air pressure in the pneumatic cylinder assemblies to raise or lower the vehicle height.
|
Gate Solenoid Valve (No. 2 Height Control Valve Sub-assembly)
| Opens or closes the passage between the pneumatic cylinder assemblies LH and RH.
|
Suspension Control ECU
| - Estimates vehicle condition based on the signals from sensors and switches, and outputs the control signals to the compressor and valves.
- Blinks the height control manual indicator light when a system malfunction is detected.
- Detects the rear left body vertical accelerated motion.
|
Air Suspension Relay (AIR SUS)
| Supplies electricity to the compressor motor.
|
Main Body ECU
| Receives the signals of the door courtesy light switches, and sends them to the suspension control ECU through CAN communication.
|
ECM
| Sends the engine speed signal and shift position signal to the suspension control ECU through CAN communication.
|
Skid Control ECU
| Receives the signals of the stop light switch and speed sensors, and sends them to the suspension control ECU through CAN communication.
|