AIR SUSPENSION SYSTEM (w/ AVS) > DIAGNOSIS SYSTEM |
| CHECK DLC3 |
Check the DLC3 (Click here).
| DTCs (Normal mode) |
DTCs are memorized in the suspension control ECU and read by using the intelligent tester (Click here).
| TEST MODE |
By switching from normal mode into test mode, you can inspect the height control switch, height control mode select switch, and absorber control switch (Click here).
| CHECK INDICATOR LIGHT |
Turn the ignition switch to ON.
Check that the height control MAN. indicator light and the height control indicator light come on for 2 seconds. If the indicator check result is not normal, proceed to troubleshooting for the CAN Communication System (Click here).