AIR SUSPENSION SYSTEM (w/o AVS) > TEST MODE PROCEDURE |
| TEST MODE PROCEDURE (SIGNAL CHECK) |
Turn the ignition switch off.
Check that the shift lever is in P.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and the intelligent tester on.
Enter the following menus: Chassis / Air suspension / Utility / Signal Check.
The engine is started without stepping on the brake pedal.
![]() |
Check that the height control manual indicator light comes on for several seconds and then blink in Test Mode.
Set each of the check items to the condition shown under Operation in the test mode table below.
| Check Item | Operation |
| Height control switch signal | Press the height control switch "UP" first and then press "DOWN" |
| Height control mode select switch signal | ON to OFF (Height control mode select switch pushed) |
Read the test mode DTCs by following the prompts on the intelligent tester screen.
Check the malfunction using the code table below. After completing the test mode, disconnect the intelligent tester and turn the ignition switch off.
| TEST MODE DTC CHART |
If a trouble code is displayed during the test mode DTC check, check the circuit listed for that code. For details of each code, refer to "See page" for the respective "DTC Code" in the chart.
| DTC Code | Diagnosis | Trouble Area | See page |
| C1792 | Height control switch circuit malfunction |
|
Click here
|
| C1793 | Height control OFF switch circuit malfunction |
|
Click here
|