SUSPENSION CONTROL ECU > REMOVAL |
| 1. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY |
![]() |
Raise the handle, detach the 4 guides and remove the No. 2 deck board.
| 2. REMOVE LUGGAGE COMPARTMENT TRIM BOX |
![]() |
Remove the 4 caps.
![]() |
Remove the 4 bolts and luggage compartment trim box.
| 3. REMOVE ROPE HOOK ASSEMBLY |
![]() |
Remove the bolt and rope hook.
| 4. REMOVE NO. 1 DECK BOARD SUB-ASSEMBLY |
![]() |
Detach the 5 clips and remove the No. 1 deck board.
| 5. REMOVE DECK BOARD REINFORCEMENT SUB-ASSEMBLY |
![]() |
Remove the 4 bolts and deck board reinforcement.
| 6. REMOVE DECK BOARD BRACKET |
![]() |
Remove the 2 bolts and deck board bracket.
| 7. REMOVE REAR SEAT CUSHION HINGE LOWER COVER LH |
| 8. REMOVE REAR FLOOR STEP NO. 1 COVER |
![]() |
Using a screwdriver with its tip wrapped in protective tape, detach the 2 claws and remove the cap.
| 9. REMOVE REAR FLOOR STEP NO. 2 COVER |
![]() |
Using a screwdriver with its tip wrapped in protective tape, detach the 2 claws and remove the cap.
| 10. REMOVE REAR DOOR SCUFF PLATE LH |
| 11. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH |
| 12. REMOVE ROPE HOOK ASSEMBLY |
![]() |
Using a screwdriver with its tip wrapped in protective tape, detach the 2 claws and remove the cover.
![]() |
Remove the bolt and the rope hook.
| 13. REMOVE REAR FLOOR MAT SUPPORT PLATE |
![]() |
Detach the 5 clips and 4 claws, and remove the rear floor mat support plate.
| 14. REMOVE QUARTER TRIM PANEL ASSEMBLY LH |
![]() |
Detach the 3 claws and remove the outer lap belt anchor cover.
![]() |
Remove the bolt and outer lap belt anchor.
![]() |
Remove the bolt and outer lap belt anchor.
![]() |
Using a screwdriver with its tip wrapped in protective tape, detach the 2 claws and remove the cover.
Remove the 2 bolts and 2 clips.
Detach the 11 clips.
Disconnect the connector and remove the quarter trim panel.

| 15. REMOVE SUSPENSION CONTROL ECU (w/o AVS) |
![]() |
Disconnect the suspension control ECU connector.
Remove the bolt and suspension control ECU.
| 16. REMOVE SUSPENSION CONTROL ECU (w/ AVS) |
![]() |
Disconnect the 3 suspension control ECU connectors.
Remove the 3 bolts and suspension control ECU.