Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM

DTC    B1242    Wireless Door Lock Tuner Circuit Malfunction

for Preparation Click here


DESCRIPTION

The door control receiver receives signals from the transmitter and sends these signals to the main body ECU.

DTC Code
DTC Detection Condition
Trouble Area
B1242
In diagnostic mode, an applicable RDA signal cannot be received within 1 second after an PRG signal has been output from the main body ECU.
  1. Wire harness or connector
  2. Door control receiver
  3. Main body ECU

WIRING DIAGRAM


B219798E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - DOOR CONTROL RECEIVER)


    E145679E03
  1. Disconnect the H3 main body ECU connector and the O25 door control receiver connector.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      H3-12 (RDA) - O25-2 (RDA)
      Always
      Below 1 Ω
      H3-12 (RDA) - Body ground
      Always
      10 kΩ or higher
      H3-10 (PRG) - O25-3 (PRG)
      Always
      Below 1 Ω
      H3-10 (PRG) - Body ground
      Always
      10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (DOOR CONTROL RECEIVER - BATTERY AND BODY GROUND)
B175276E04
  1. Disconnect the O25 door control receiver connector.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    O25-1 (GND) - Body ground
    Always
    Below 1 Ω

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    O25-5 (+B) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE DOOR CONTROL RECEIVER
  1. Replace the door control receiver with a normal one (Click here).

    HINT:
    If a normally functioning door control receiver is available, connect it and check if the wireless door lock function is normal or DTCs are output. If the alternative receiver functions normally, replace the original door control receiver.


NEXT


4.REGISTER RECOGNITION CODE
  1. Perform the registration procedures (Click here).


NEXT


5.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


6.CONFIRM DTC
  1. Check if the same DTC is detected.

    HINT:
    Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for DTCs.

    OK:
    DTC is not output.



NG
REPLACE MAIN BODY ECU
OK

END (DOOR CONTROL RECEIVER DEFECTIVE)