DTC C1267 Brake Pedal Load Sensing Switch |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1267 | During cruise control operation a micro switch error is stored under the following conditions: A micro switch error flag remains ON for 0.5 seconds or more, the micro switch condition does not match the signal sent from the VSC system, or the micro switch and oil pressure sensor values do not match for 1 second or more. |
|

| 1.CHECK FOR DTCS (FOR VEHICLE STABILITY CONTROL SYSTEM) |
Check for DTCs in Vehicle Stability Control System (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - ECM) |
![]() |
Disconnect the A27 connector from the ECM.
Disconnect the A19 connector from the ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A19-40 (PSOO) - A27-36 (STV) | Always | Below 1 Ω |
| A19-40 (PSOO) or A27-36 (STV) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.REPLACE VSC ACTUATOR ASSEMBLY |
Temporarily replace the VSC actuator assembly with a new or normally functioning one (Click here).
| NEXT | |
| 4.CLEAR THE DTC |
Clear the DTC (Click here).
| NEXT | |
| 5.CHECK FOR DTC |
Check for DTC (Click here).
|
| ||||
| OK | ||
| ||