THEFT DETERRENT SYSTEM > Horn Circuit |

| 1.INSPECT HORN |
Press the horn switch and check if the horns sound.
| Result | Proceed to |
| Horns sound | A |
| Horns do not sound | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (VEHICLE HORN) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester main switch on.
Select the item below in the Active Test and then check that the horns operate.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Vehicle Horn | Vehicle horns | ON/OFF | - |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ENGINE ROOM JUNCTION BLOCK) |
Disconnect the DB main body ECU connector.

Remove the integration relay from the engine room junction block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| DB-1 - 1A-7 | Always | Below 1 Ω |
| DB-1 or 1A-7 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||