Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR (for Rear Side)

ULTRASONIC SENSOR (for Rear Side) > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER

HINT:
Use the same procedure to install the No. 1 ultrasonic sensor retainer on the other side.



    E146471E01
  1. Install the ultrasonic sensor retainer to the rear bumper.

    HINT:
    When installing the retainer, align the keyhole and snap as shown in the illustration.

    NOTICE:
    Do not damage the bumper with the snap when installing the retainer.



2. INSTALL NO. 1 ULTRASONIC SENSOR

HINT:
Use the same procedure to install the No. 1 ultrasonic sensor on the other side.



    E146472
  1. Attach the 2 claws to install the ultrasonic sensor.

  1. Connect the connector.



3. INSTALL NO. 2 ULTRASONIC SENSOR RETAINER

HINT:
Use the same procedure to install the No. 2 ultrasonic sensor retainer on the other side.



    E146473E01
  1. Install the ultrasonic sensor retainer to the rear bumper.

    HINT:
    When installing the retainer, align the keyhole and snap as shown in the illustration.

    NOTICE:
    Do not damage the bumper with the snap when installing the retainer.



4. INSTALL NO. 2 ULTRASONIC SENSOR

HINT:
Use the same procedure to install the No. 2 ultrasonic sensor on the other side.



    E146466
  1. Attach the 2 claws to install the ultrasonic sensor.

  1. Connect the connector.



5. INSTALL REAR BUMPER COVER


B191656
  1. Attach the 12 claws to install the rear bumper cover.



    B195443
  1. Attach the 2 harness clamps and connect the connector.



    B191655E01
  1. Install the 6 bolts for upper side of the rear bumper cover.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Install the 2 bolts for lower side of the rear bumper cover.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

  1. Install the 2 screws and the 2 clips.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



6. INSTALL REAR QUARTER PANEL MUDGUARD LH


B191653
  1. Install the rear quarter panel mudguard with the clip.

  1. Install the 9 screws.



7. INSTALL REAR QUARTER PANEL MUDGUARD RH

HINT:
Use the same procedure as for the LH side.