ULTRASONIC SENSOR (for Front Side) > INSTALLATION |
| 1. INSTALL NO. 2 ULTRASONIC SENSOR |
Attach the 4 claws to install the No. 2 ultrasonic sensor as shown in the illustration.

| *a | No. 2 ultrasonic sensor direction | *b | Keyhole direction |
| 2. INSTALL FRONT BUMPER COVER |
![]() |
Attach the 4 claws to install the front bumper cover.
Connect the connectors.
![]() |
Install the 8 clips.
Install the 7 screws.
![]() |
Install the 2 pin hold clips.
Install the clip.
Install the screw.
| 3. INSTALL FRONT END PANEL LH (w/o Headlight Cleaner System) |
![]() |
Attach the 2 clips to install the front end panel.
![]() |
Install the 2 clips.
| 4. INSTALL FRONT END PANEL RH (w/o Headlight Cleaner System) |
| 5. INSTALL FRONT END PANEL LH (w/ Headlight Cleaner System) |
![]() |
Attach the 2 claws and 2 clips to install the front end panel.
![]() |
Install the 2 clips.
| 6. INSTALL FRONT END PANEL RH (w/ Headlight Cleaner System) |
| 7. PREPARE VEHICLE FOR FOG LIGHT AIMING ADJUSTMENT (w/ Fog Light) |
Prepare the vehicle:
| 8. PREPARE FOR FOG LIGHT AIMING (w/ Fog Light) |
![]() |
Prepare the vehicle.
| *a | 90 ° |
| *b | 25 m or 3 m |
Prepare a piece of thick white paper approximately 2.0 m (6.56 ft.) (height) x 4.0 m (13.1 ft.) (width) to use as a screen.
Draw a vertical line down the center of the screen (V line).
Set the screen as shown in the illustration.

![]() |
Draw base lines (H line, V LH, V RH lines) on the screen as shown in the illustration.
| *a | V LH Line |
| *b | V Line |
| *c | V RH Line |
| *d | H Line |
| *e | Ground |
H Line (Fog light height):
Draw a horizontal line across the screen so that it passes through the center marks. The H line should be at the same height as the fog light bulb center marks of the fog lights.
V LH Line, V RH Line (Center mark position of left-hand (LH) and right-hand (RH) fog lights):
Draw 2 vertical lines so that they intersect the H line at each center mark.
| 9. INSPECT FOG LIGHT AIMING (w/ Fog Light) |
Cover the fog light or disconnect the connector of the fog light on the opposite side to prevent light from the fog light that is not being inspected from affecting the fog light aiming inspection.
Start the engine.
Turn on the fog lights and check if the upper edge of the hot zone for each fog light matches the upper edge as shown in the illustration.

| 10. ADJUST FOG LIGHT AIMING (w/ Fog Light) |
![]() |
Adjust the aim vertically:
| *1 | Aiming Screw |