Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR (for Rear Side)

ULTRASONIC SENSOR (for Rear Side) > INSTALLATION

for Preparation Click here



1. INSTALL NO. 2 ULTRASONIC SENSOR


  1. Attach the 4 claws to install the No. 2 ultrasonic sensor as shown in the illustration.

    HINT:
    1. No. 2 ultrasonic sensor direction is the same as the keyhole direction.
    2. Do not damage the bumper with the protrusion when installing the No. 2 ultrasonic sensor.



    B354822E04


    Text in Illustration 
    *a
    No. 2 ultrasonic sensor direction
    *b
    Keyhole direction



2. INSTALL REAR BUMPER COVER


B191656
  1. Attach the 12 claws to install the rear bumper cover.



    B195443
  1. Attach the 2 harness clamps and connect the connector.



    B191655E01
  1. Install the 6 bolts for upper side of the rear bumper cover.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Install the 2 bolts for lower side of the rear bumper cover.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

  1. Install the 2 screws and the 2 clips.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



3. INSTALL REAR QUARTER PANEL MUDGUARD LH


B191653
  1. Install the rear quarter panel mudguard with the clip.

  1. Install the 9 screws.



4. INSTALL REAR QUARTER PANEL MUDGUARD RH

HINT:
Use the same procedure as for the LH side.