ULTRASONIC SENSOR (for Rear Side) > REMOVAL |
| 1. REMOVE REAR QUARTER PANEL MUDGUARD LH |
![]() |
Remove the 9 screws.
Remove the clip and rear quarter panel mudguard.
| 2. REMOVE REAR QUARTER PANEL MUDGUARD RH |
| 3. REMOVE REAR BUMPER COVER |
![]() |
Apply protective tape as shown in the illustration.
![]() |
Remove the 8 bolts, 2 screws and 2 clips.
![]() |
Detach the 2 harness clamps and disconnect the connector.
![]() |
Detach the 12 claws and remove the rear bumper cover.
| 4. REMOVE NO. 1 ULTRASONIC SENSOR |
Disconnect the connector.
![]() |
While pushing down on the lever with a finger to release the claw, disengage the claw on the other side to remove the ultrasonic sensor.
| 5. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER |
![]() |
Detach the 2 claws and remove the ultrasonic sensor retainer from the rear bumper.
| 6. REMOVE NO. 2 ULTRASONIC SENSOR |
Disconnect the connector.
![]() |
While pushing down on the lever with a finger to release the claw, disengage the claw on the other side to remove the ultrasonic sensor.
| 7. REMOVE NO. 2 ULTRASONIC SENSOR RETAINER |
![]() |
Detach the 2 claws and remove the ultrasonic sensor retainer from the rear bumper.