Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR (for Front Side)

ULTRASONIC SENSOR (for Front Side) > REMOVAL

for Preparation Click here



1. REMOVE FRONT END PANEL LH (w/o Headlight Cleaner System)


    B191650
  1. Remove the 2 clips.



    B191651
  1. Detach the 2 clips and remove the front end panel.



2. REMOVE FRONT END PANEL RH (w/o Headlight Cleaner System)

HINT:
Use the same procedure as for the LH side.



3. REMOVE FRONT END PANEL LH (w/ Headlight Cleaner System)


    B191650
  1. Remove the 2 clips.



    B191652
  1. Detach the 2 claws and 2 clips and remove the front end panel.



4. REMOVE FRONT END PANEL RH (w/ Headlight Cleaner System)

HINT:
Use the same procedure as for the LH side.



5. REMOVE FRONT BUMPER COVER


    B220207E01
  1. Apply protective tape, as shown in the illustration.



    B194112E01
  1. Using a screwdriver, remove the 2 pin hold clips.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Using a clip remover, remove the clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Remove the screw.

    HINT:
    Use the same procedure for the RH side and LH side.



    B220208
  1. Remove the 8 clips.

  1. Remove the 7 screws.



    B220209
  1. Detach the 4 claws and remove the front bumper cover.

  1. Disconnect the connectors.

    HINT:
    If vehicle equipped with fog lights or ultrasonic sensors, disconnect the connectors.



6. REMOVE NO. 2 ULTRASONIC SENSOR


  1. Detach the 4 claws and remove the No. 2 ultrasonic sensor as shown in the illustration.

    HINT:
    The illustration shows the No. 2 ultrasonic sensor for the RH. The horizontal orientation of the No. 2 ultrasonic sensor for the LH is opposite that of the image shown in the illustration.



    B354819