Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR (for Rear Side)

ULTRASONIC SENSOR (for Rear Side) > REMOVAL

for Preparation Click here



1. REMOVE REAR QUARTER PANEL MUDGUARD LH


B191653
  1. Remove the 9 screws.

  1. Remove the clip and rear quarter panel mudguard.



2. REMOVE REAR QUARTER PANEL MUDGUARD RH

HINT:
Use the same procedure as for the LH side.



3. REMOVE REAR BUMPER COVER


B191654E01
  1. Apply protective tape as shown in the illustration.



    B191655E01
  1. Remove the 8 bolts, 2 screws and 2 clips.



    B195443
  1. Detach the 2 harness clamps and disconnect the connector.



    B191656
  1. Detach the 12 claws and remove the rear bumper cover.



4. REMOVE NO. 2 ULTRASONIC SENSOR


Detach the 4 claws and remove the No. 2 ultrasonic sensor as shown in the illustration.

HINT:
The illustration shows the No. 2 ultrasonic sensor for the LH corner and back sensor RH. The horizontal orientation of the No. 2 ultrasonic sensor for the RH corner and back sensor LH is opposite that of the image shown in the illustration.



B354819